And after that the switch, CP, AP just reacts on the response. The RADIUS only tells "yes" or "no" in simple words. The user send the credetials to one of these three parts.Īfter this the switch, captiveportal, AP first block the access of the client until they get a positive response from the RADIUS. I am no RADIUS expert but think about that:Ī client is connected to a switch, access point, captiveportal. How can one force each FreeRADIUS user to use specific network settings after they have been successfully authenticated? Sending Access-Accept of id 225 to 192.168.1.1 port 41977īut fails to force the user to use IP Address 192.168.1.27. If I only set the IP address tab, FreeRADIUS does accept the login: When I set subnetmask and gateway at the FreeRADIUS: Users tab, each user is unable to login at the captive portal page saying "Login incorrect: (from client cportal port 2 cli 00:00:00:00:1a:00)" ![]() ![]() Moreover, I'd like to specify which ip address, subnetmask and gateway each user should be forced to use. What I am trying to do is set up a captive portal with all users and their attributes stored in FreeRADIUS. ![]() ![]() I am new to both FreeRADIUS and pfSense so please forgive me if this is a stupid question.
0 Comments
Leave a Reply. |